|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
Information |
|
air charge pipe partViews : 303 Replies : 3Users Viewing This Thread : |
|
Thread Tools | Display Modes |
May 12th, 2018, 23:27 | #1 |
Junior Member
Last Online: Jun 17th, 2018 14:57
Join Date: Apr 2013
Location: stevenage
|
air charge pipe part
I have twin throttle body type and the left hand air inlet pipe came adrift on motorway.by the time i could stop and sort it out the rubber ring bit that fits on end at throttle body where clip goes was gone i fitted pipe on without it but now have a loose fit causing poor running.
can anyone tell me what this part is called or its part number or if it is available on its own thanks alan Last edited by oyvolvo; May 12th, 2018 at 23:43. Reason: change photo |
May 13th, 2018, 06:44 | #2 |
Premier Member
Last Online: Feb 4th, 2023 15:10
Join Date: Apr 2015
Location: uk
|
im sure its charge air hose it goes from twin inlet flap runs down osf to intercooler they may have redesigned them to rubber hose not 100%sure on that though something tells me they have
regards |
May 13th, 2018, 07:11 | #3 |
Premier Member
Last Online: Yesterday 16:16
Join Date: Apr 2013
Location: Plymouth
|
Hi
My hose split on my v50 Was plastic, new one rubber. Item 4 About £90 if I remember. The Ford part might be cheaper so have put the FoMoCo number(stamped on the new Volvo hose) as well. Just check it is the same part number first for your engine. Had to take the front of the car off to do it. However it comes apart easily, took about an hour in total. Iain Last edited by IainG; May 13th, 2018 at 07:18. |
May 13th, 2018, 09:05 | #4 |
Junior Member
Last Online: Jun 17th, 2018 14:57
Join Date: Apr 2013
Location: stevenage
|
Thanks all for info
From what you say it seems that the new design is all one part then and doesnt have a seperate rubber seal at throttle end. As the plastic section of mine is fine and new one is expensive and hard to refit I will see if i can bodge up a replacement rubber bit from a suitable hose. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|