|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
Information |
|
Brighten your headlamps, for free!Views : 19205 Replies : 93Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Feb 14th, 2019, 17:01 | #91 |
C30 R-Design
Last Online: Dec 21st, 2023 13:45
Join Date: Feb 2013
Location: Cumbria
|
Last night decided to take my projectors out so I could check and clean them before making a decision on buying retrofitlab replacements.... The lenses were a little misty but cleaned up very nicely and the reflectors weren't in too bad a condition...... Big improvement in the dark this morning on my commute..... Just saved myself a good few quid....
|
The Following 3 Users Say Thank You to TheFiend For This Useful Post: |
Jul 26th, 2019, 16:16 | #92 |
Junior Member
Last Online: Apr 17th, 2024 18:50
Join Date: Sep 2016
Location: Dublin
|
Tried to take apart the headlight to give a bit of clean to the projector. All good until the screw in the image, there is NO way to be able to remove it. The screw goes as far as the plastic in the image.
That's it, I gave up.
__________________
2007 V50 1.6D SE in Black - DPF off & Remap |
Jul 26th, 2019, 16:47 | #93 | |
WowIcanwriteAnythingHere!
Last Online: Mar 26th, 2024 16:05
Join Date: May 2016
Location: Dublin/Meath
|
Quote:
trust me, did it 4 times already and I vouch its possible :P
__________________
2005 V50 T5AWD M66, Stage1 Hilton tune E-focus torque mount, E46 bi-xenon retrofit v2 , (also available in PDF form), DTSC fully-off mod, Brembo discs+ATE ceramic pads |
|
Jul 26th, 2019, 17:15 | #94 |
Junior Member
Last Online: Apr 17th, 2024 18:50
Join Date: Sep 2016
Location: Dublin
|
Well, finally I did it. I used the soldering iron with a thicker tip to make a nice and lovey way out of the screw, without forcing anything. Have to be very careful with 250℃ soldering iron in that area.
Was not any dust on it, just a tiny bit of.... let's call it dirt.
__________________
2007 V50 1.6D SE in Black - DPF off & Remap |
The Following User Says Thank You to emy For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|