What tool did you use?

PLANT · Dec 29th, 2007, 00:44

Howdy,

Need to replace the globes that light up the headlight switch in dash.
Used a mini screw driver to loosen the globe but they are still stuck in there postion.
Tried to use a paperclip no go.
Twezzers nope.
Will try long nose pliers with the point bit ffaces down.

So what tool did you use that worked?

AHHHHHHHH!

pringle_addict · Dec 30th, 2007, 11:18

I was lucky I guess and used a flat blade screwdriver that was nice snug fit in the lamp, so when I retracted the driver, the lamp unit was attached.

I think on one of them though, a gentle knock into the palm of my hand was required.

Good luck!

Dec 29th, 2007, 00:44	#1
PLANT Junior Member Last Online: Apr 2nd, 2024 07:55 Join Date: Jan 2006 Location: MELBOURNE View Photos By: PLANT	What tool did you use? Howdy, Need to replace the globes that light up the headlight switch in dash. Used a mini screw driver to loosen the globe but they are still stuck in there postion. Tried to use a paperclip no go. Twezzers nope. Will try long nose pliers with the point bit ffaces down. So what tool did you use that worked? AHHHHHHHH!

Dec 30th, 2007, 11:18	#2
pringle_addict Senior Member Last Online: Jan 30th, 2024 14:21 Join Date: Nov 2007 Location: St Ives, Cambs View Photos By: pringle_addict	What tool did you use? I was lucky I guess and used a flat blade screwdriver that was nice snug fit in the lamp, so when I retracted the driver, the lamp unit was attached. I think on one of them though, a gentle knock into the palm of my hand was required. Good luck!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)