|
Trader's Offers & Discounts A forum for discussing special offers that are available to VOC or Forum members. Commercial organisations must first seek permission to post details of products. |
Information |
|
Problem with ETM DIM or NAVI??? Cheap services hereViews : 212148 Replies : 243Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jan 13th, 2019, 19:41 | #231 |
New Member
Last Online: Apr 18th, 2022 18:32
Join Date: Jan 2019
Location: AMERSHAM
|
Hi Lukas,
I have a 2008 MY (Gen 3) V70 D5 SE Geartonic with an intermittent fault that I suspect is the DIM. Sometimes when cold the dash shows faults on SRS, ABS and TC together with the usual red and amber flashing lights and sounds. Sometimes the indicators also stop working and often the speedo and rpm gauges show zero. The radio and associated LCD display have also stopped working, but this could be unrelated. On your Online shop you only show an older DIM for repair. Does this also cover later DIMs? |
Jan 13th, 2019, 23:18 | #232 |
Trader
Last Online: Dec 6th, 2023 19:46
Join Date: Jun 2010
Location: london
|
Hi
I dont think your problem is related to speedometer at all. Would suggest to run diagnostic and double check before sending speedo to me. Regards Lukas |
Jan 14th, 2019, 13:06 | #233 |
New Member
Last Online: Apr 18th, 2022 18:32
Join Date: Jan 2019
Location: AMERSHAM
|
Lukas, I have a standard OBD2 scanner which shows no recorded DTCs.
If you have a sophisticated diagnostic tool which might point to where to fault is I could drive round the M25 to you in Rainham. The problem is that the fault only shows when the car is cold. |
Jan 14th, 2019, 18:26 | #234 |
New Member
Last Online: Jul 14th, 2023 10:00
Join Date: Nov 2008
Location: Sleaford
|
V70 T5 1999 hunting at idle
Hi Lukas,
My 2.3 T5 estate has had a long running problem with hunting at idle. It varies occasionally in degree but is nearly always there. I've attempted nothing so far but I am considering cleaning the throttle bodies butterfly valves as described in many places. Unfortunately since last year a 'normal' idle is a requirement for the MOT and my car has just failed this. The garage where it is now has quoted £250 for a second hand throttle bode unit plus fitting. I'm not going to go for that but am contemplating bringing it home and stripping the throttle body unit. I would appreciate any advice on diagnostic steps I could follow and/or sending the unit to you for refurbishment. Thanks in advance, Dave M |
Jul 28th, 2019, 15:19 | #235 |
Junior Member
Last Online: Mar 15th, 2024 21:21
Join Date: Jan 2007
Location: Didcot
|
Hi Lukas
I have a 2002 V70 D5 SE with about 125,000 miles on the clock. I have had intermittent problems with the dashboard clock spinning for a couple of years and today I noticed the indicator tell-tales on the dash weren't working, then when I stopped and parked up the speedo and tacho needles remained vertical. When I came back to the car 2 hours later the needles had returned to 0 but on turning on the ignition the only visible light I got was the amber engine management light which went out on starting, but none of the instruments or other lights/displays were working at all. I did a scan with my BSR PPC scanner and recorded the following faults: CCM001F - always there! DIM0003 DIM0005 SRS00D4 Whilst erasing the faults for the second time the dashboard came back to life and now appears to be functioning normally, other than the clock spinning when trying to set the time and all the codes (other than CCM001F) have gone and not reappeared after a run. Am I right in assuming this is the well known DIM issue with this model and should I now send it off to you for a refurb? Cheers John Underhill
__________________
52 Silver V70 D5 SE Manual |
Jul 29th, 2019, 19:49 | #236 |
Master Member
Last Online: Yesterday 06:42
Join Date: Jan 2015
Location: Blackpool
|
CCM001F = air quality sensor wanting replacing as the crystals inside are no longer sampling correctly
DIM0003 = The Code is stored if the DIM detects an internal open circuit in the circuit for the SRS Warning Lamp DIM0005 = Red General Warning Lamp does not light, The Code is stored if the DIM detects an internal open circuit in the circuit for the General Red Warning Lamp. SRS00D4 = This Code is stored if the SRS module recieves a CAN signal indicating that the LED in the Combined Intrument Panel (DIM) is broken. Hope this helps you out
__________________
To stupidity & beyond |
The Following User Says Thank You to dingov70 For This Useful Post: |
Aug 1st, 2019, 15:27 | #237 | |
Junior Member
Last Online: Mar 15th, 2024 21:21
Join Date: Jan 2007
Location: Didcot
|
Quote:
I duly sent it RM special Delivery by 1pm and it arrived at 12.10pm on Wednesday 31st July. it was delivered to my door fully repaired the next morning 1st August at 1030am. Absolutely no issues or codes on reinstallation and everything now works as it should. Absolutely brilliant service - thank you Lukas
__________________
52 Silver V70 D5 SE Manual |
|
Sep 27th, 2019, 10:40 | #238 |
Senior Member
Last Online: Apr 6th, 2024 18:23
Join Date: Oct 2016
Location: aberaeron,wales
|
p/m sent
|
Sep 30th, 2019, 09:39 | #239 |
New Member
Last Online: Oct 18th, 2019 13:41
Join Date: Oct 2006
Location: London
|
Probably going to need a CEM repair to sort my water ingress issues: https://www.volvoforums.org.uk/showthread.php?t=298662
Lukas - I've just sent an enquiry form through, if it looks fixable I might take the day off on Wednesday and pop over to Rainham. Easy enough to get to from north London and I could do with a break :-D |
Oct 2nd, 2019, 13:51 | #240 |
Senior Member
Last Online: Apr 6th, 2024 18:23
Join Date: Oct 2016
Location: aberaeron,wales
|
new clocks came today ,plugged in and hay presto a fully working dash thanks to lukas for a quick speedy turn around top guy
|
The Following User Says Thank You to jim jordan For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|