S40 (New) Brakes : BCM code 0101

[Immy]

Hi all,

update on the below.

It turned out to be a blocked sump and faulty turbo, which both have now been replaced, and it runs sweet.

Originally Posted by Immy

Hi guys,

My S40 1.6d goes into limp mode and anti skid message appears when i go over 45mph, turned it off and back on all good till I hit 45mph, since then now the car goes into limp mode and have anti skid service message on after 20 seconds from starting.

Garage did following work:
Egr replaced, full service inc fuel filter, dpf was cleaned by garage, injectors checked, tcv replaced

I ran vida on it and the first message I get is about resetting information about current consumption necessary

Also the following codes

bcm-0101
ecm-1600
ecm-7700
pam-e010

Files attached below

I navigated to diganostics/vehicle/communcation/ecm/advanced/battery monitoring module (bms) resetting of information about current supply.
It had erase codes, read codes, earse ecm. Cleared codes and same codes came back on.

Do I need to select earse ecm? as was not sure if this would delete all software etc, so dind't click it.

Is it the battery that is at fault due to the full screen message?

Any help very much appreciated, thanks all

https://drive.google.com/open?id=16V...fG3P_vLC8oT4BA

https://drive.google.com/open?id=1pk...xi2s8RvtIQd3KT

https://drive.google.com/open?id=13T...8Rdvwj4Y3r1FQ-