|
S80 '98-'06 / S60 '00-'09 / V70 & XC70 '00-'07 General Forum for the P2-platform S60 / V70 / XC70 / S80 models |
Information |
|
Chassis setting service requiredViews : 1582 Replies : 3Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Dec 24th, 2010, 18:20 | #1 |
weighing things up
|
Chassis setting service required
This morning, I get into my car and start it up, drive out of the garage and perform a three point turn as the double garage is at 90 deg to the house and the road. I stop, get out as I had forgotten something, so goes back into the house gets what I have for gotten and get back into the car and I see on the dash a yellow triangle and I press READ and its flashes up Chassis Setting Service Required. So I take it easy on my way into work. When I came home this afternoon, the message was not there.
So my question is, why did it show that message if it was not to stay on after I had turned off the engine. Or was it her time of the month? Thanks |
Dec 24th, 2010, 19:28 | #2 |
Experienced Member
Last Online: Today 16:01
Join Date: Jun 2007
Location: L/H side
|
You seem to have an intermittant fault with the Four - C system , best get the fault codes read i guess ..
__________________
My comments are only based on my opinions and vast experience . |
Dec 24th, 2010, 21:37 | #3 |
weighing things up
|
|
Feb 5th, 2011, 11:44 | #4 |
weighing things up
|
Just thought I would up-date you all on this. Sorry for the delay.
Two weeks ago I booked my car into Bells (Northampton) and asked them to carry out a full health check, work out why my n/s headlight wiper was not working, replace a front slide light bulb and check out the Chassis Setting Service required message and finally carry out 4-wheel alignment. I had to have a new headlight wiper motor had to be ordered in and I had booked the car in for this to be replaced today. Whilst I had it booked in said can you look at the hassis Setting Service required that I am still getting. The message I was getting was due to the fact that the suspension sensor was incorrectly fitted to the strut - SUM - 0013 code was found. A few days later I still got this message. Phoned the garage up and mentioned it. I took the car back in today to have a headlight wiper motor replaced and asked them to look at the message again. They found that the acceleration sensor is missing. I am surprised that they did not pick this up when they did the health check. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|