|
Information |
|
MAF Sensor Wanted for my 2001 2.0TViews : 3445 Replies : 23Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jan 1st, 2014, 14:35 | #1 |
New V40 Owner
Last Online: Sep 21st, 2022 22:03
Join Date: May 2013
Location: London
|
MAF Sensor Wanted for my 2001 2.0T
Hi Folks,
Happy New Year to you all ! I'm in need of a "known to be good" MAF for my 2001 V40 2.0T (B4204T3) Looking at VIDA the part number for 2001 onwards is 30611532 Thanks Very much ! Neil
__________________
London, UK Current Car - 1999 T4 V40 Ph1 66k AKA "Heather" My Previous Car: V40 2.0T 2000 Volvo V40 2.0T (B4204T3) |
Jan 1st, 2014, 15:55 | #2 |
Member
Last Online: Aug 6th, 2020 14:48
Join Date: Mar 2013
Location: Kuala Lumpur
|
i have one..
|
Jan 1st, 2014, 15:57 | #3 |
GoldMember
Last Online: May 23rd, 2024 22:03
Join Date: Jul 2010
Location: Kent, UK
|
Some info incase its useful
Does your MAF have a 3 pin plug?, it should put out an analog voltage (on the middle pin) somewhere from 0.8v(tickover) to 1.5V+ as engine revs increase.
Its worth checking you have +12v supply to the MAF (outer pins), this isnt present with just the ignition on but +12v should be here once the engine is cranked/running.. There is from memory a grey multiway plug low down in the engine bay that can cause problems, worth locating this and using some switch cleaner and a few plugs/unplugs to make sure its not a poor connection here causing your troubles.. |
Jan 1st, 2014, 16:10 | #4 |
New V40 Owner
Last Online: Sep 21st, 2022 22:03
Join Date: May 2013
Location: London
|
Thanks Thassos I will go and have look and check the voltage
I took my car to Gatos' house and we plugged it up to his DICE and it looks like there is a problem with the MAP on the inlet manifold and the MAF because is was cutting out on idle but when we unplugged the MAF it idled fine if a little rich smelling. Driving it home with the MAF disconnected didn't allow me to put my foot down to accelerate properly at all and if i did i would lose power completely and i had to feather the throttle to get it to pick up again. And thanks syahizad but surely sending from so far away will cost more than the unit is worth ?
__________________
London, UK Current Car - 1999 T4 V40 Ph1 66k AKA "Heather" My Previous Car: V40 2.0T 2000 Volvo V40 2.0T (B4204T3) |
Jan 1st, 2014, 18:07 | #5 | |
New V40 Owner
Last Online: Sep 21st, 2022 22:03
Join Date: May 2013
Location: London
|
Quote:
The MAF has a 3 pin plug there was 12v on one of the pins and 0.07v on the middle pin (forgot to rev it to check if it went up) and nothing on the 3rd. I could see the big greay connector but couldnt work out how to unplug it, what looked like the push release clip wouldnt move or release the connector when i pushed it.
__________________
London, UK Current Car - 1999 T4 V40 Ph1 66k AKA "Heather" My Previous Car: V40 2.0T 2000 Volvo V40 2.0T (B4204T3) |
|
Jan 1st, 2014, 22:00 | #6 |
GoldMember
Last Online: May 23rd, 2024 22:03
Join Date: Jul 2010
Location: Kent, UK
|
MAF or wiring to?
I agree, not good weather for poking around under car bonnets..
It sounds like the power is getting to the sensor ok, so does seem like the MAF isnt putting out a voltage, Re the bulkhead connector - most connectors have locking clips usually something you have to press in before being able to separate one side, you could try testing the MAF indoors by applying 12v (in same polarity as wiring in car) then just put the dvm on the centre pin (this would rule a out a short or similar on the wiring from MAF to ECU) then try blowing some air past the sensor, a working sensor would show an increasing voltage with airflow past it. |
Jan 1st, 2014, 22:14 | #7 | |
New V40 Owner
Last Online: Sep 21st, 2022 22:03
Join Date: May 2013
Location: London
|
Quote:
When i went to Gatos' house the readin from DICE while we were running was just one fixed value so it certainly looked like it was stuck, but other parameters we were monitoring seemed really slow to update so the software seems a little laggy but im pretty convinced there is something wrong with the MAF
__________________
London, UK Current Car - 1999 T4 V40 Ph1 66k AKA "Heather" My Previous Car: V40 2.0T 2000 Volvo V40 2.0T (B4204T3) |
|
Jan 1st, 2014, 22:50 | #8 | |
Master Member
Last Online: May 22nd, 2024 22:34
Join Date: Dec 2011
Location: bournemouth
|
Quote:
Have you sorted one out yet? |
|
Jan 1st, 2014, 22:52 | #9 |
New V40 Owner
Last Online: Sep 21st, 2022 22:03
Join Date: May 2013
Location: London
|
Hi, no not yet, do you have one?
__________________
London, UK Current Car - 1999 T4 V40 Ph1 66k AKA "Heather" My Previous Car: V40 2.0T 2000 Volvo V40 2.0T (B4204T3) |
Jan 1st, 2014, 23:01 | #10 |
Master Member
Last Online: May 22nd, 2024 22:34
Join Date: Dec 2011
Location: bournemouth
|
Hi Neil yeah I got one that is working a 100% just got to check the part numbers in the morning but I'm pretty sure they are the same.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|