Rse problem

[SwissXC90]

Originally Posted by Danielpsmith

Swiss has showed me where the ras module is located was seeing if anyone has ever removed one I am guessing the cup holders have to come off but not sure any advice welcome if anyone has done it before thanks again.

The center console comes out very easily
It is normally a removable part held in by one catch at the rear, unless the RSE is fitted.
When the RSE is fitted, the lower catch has a banking plate and the center console is held in with 2 x screws, one each side at the rear.
Loosen the screws, press in the catches, and slide backwards.

VIDA says:
Control module rear sound separation, replacing
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal
Removing center tunnel console
Remove the arm rest at the center console according to the following three alternatives:
Alt 1 Release handle at the arm rest's lower rear edge, pull backwards.
Alt 2 Remove the 2 x screws (1). Press in the catches (2), pull backwards.
Alt 3 Remove the 2 x covers (2). Remove the 2 x screws (1), pull backwards.

(you have Alt. 2 or 3)

Remove the rear center console acc. to: Center console, replacing .

Removing rear sound separation module, vehicles without cooler

Remove:
the 4 screws
the connector, x1
the control module.

Much easier with pictures of course.
Unplug the connectors and you can remove the entire console
Once upside down you will see the RAS.