|
400 Series General Forum for the Volvo 440, 460 and 480 cars |
Information |
|
440 airbag lightViews : 1561 Replies : 2Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jan 10th, 2003, 14:10 | #1 |
Guest
Location:
|
440 airbag light
I need to know how to re-set the airbag warning light on my 440Li. its L reg 93 I think. I was repairing the horn when the airbag lead "detatched". I have re-connected it and not blown myself up (so far) :) I dont want to just remove the bulb!
Thanks..... |
Jan 15th, 2003, 19:40 | #2 |
Guest
Location:
|
RE: 440 airbag light
Not sure about volvo, but most other manufactures airbag ECUs can only be reset by the dealer tool.
Same goes for the seat belt pretentioners. |
Feb 8th, 2003, 20:27 | #3 |
Guest
Location:
|
RE: 440 airbag light
This is how you do it ;...
FIND DATA LINK CONNECTOR (DLC) UNDER BONNET N/S/F INNER WING. 1. INSERT DATA LINK CONNECTOR INTO SOCKET 7, THIS IS THE SMALL CABLE ATTACHED TO DLC. 2. SWITCH IGN ON. 3. DEPRESS DLC BUTTON FOR 1 SECOND APPROX, BUTTON ON DLC ,YOU CAN NOT MISS IT. THEN WAIT IT TAKES 1-2 SECONDS TO RESPOND 4. COUNT FLASHES. AGAIN IT TAKES A FEW SECONDS TO RUN THROUGH 5. DEPRESS DLC AGAIN FOR EACH TROUBLE CODE STORED IN SRS CONTROL MODULE MEMORY. 6. YOU MUST ACCESS FAULT CODES AT LEAST ONCE BEFORE ERASING. 7. WHEN YOU GET THE CODE 1-1-1 ALL IS DONE 8. PRESS DLC BUTTON FOR 5 SECONDS MIN. 9. RELEASE BUTTON. 10. CHECK LED ILLUMINATES. 11. PRESS DLC AGAIN FOR 5 SEC MIN WHILE THE RED LIGHT IS ON. 12. RELEASE BUTTON THEY SHOULD OF ERASED AND THE ABS LIGHT WILL GO OUT. YOU MAY NEED TO DO THIS A COUPLE OF TIMES |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|