|
700/900 Series General Forum for the Volvo 740, 760, 780, 940, 960 & S/V90 cars |
Information |
|
Missfire 960Views : 1003 Replies : 24Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jul 12th, 2019, 07:13 | #21 |
VOC Member
Last Online: Apr 12th, 2024 13:08
Join Date: Aug 2006
Location: Hounslow West London
|
Dave, thanks for that info and I like your old spanner seal remover; I'll make one out of many of my old spanners.
As my car was a company one before I bought it, I think all the issues like inlet gasket had been resolved. Just by the way; The cylinder head bolts were tight and I have a set of quailty impact sockets including a 14mm for those bolts...essential to remove them with a good extension bar. Also lifting the head off the gasket, I found that very, very gentle leverage under the thermostat housing, and the head lifted easily. As I work by myself, I jury rigged a simple pulley system to gently lift the head out; I shall need that again to replace it without damage to the gasket. I also found it easier, with the head lifted an inch up and moved forward towards the radiator, it is much easier to remove the screws and bolts holding various brackets etc from the back of the block. For the future, I'm going to change those Torx screws there for standard Hex...they only need to be nipped up. Thanks for the advice. Garth. |
The Following 2 Users Say Thank You to mjk164 For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|