|
Information |
|
Replacing Door Mirror UnitViews : 1443 Replies : 8Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jan 12th, 2016, 20:32 | #1 |
New Member
Last Online: Nov 19th, 2023 21:08
Join Date: Oct 2015
Location: OXfordshire
|
Replacing Door Mirror Unit
Anyone got a guide or info for replacing the complete passenger side wing mirror body on a V40CC, I have the new parts, can see there are 3 bolts holding it to the car and a short lead, but I'm assuming it requires removing the door card to access the bolts? in which case where are the fixings etc?
Thanks for any info, a lorry decided to remove it for us! |
Jan 13th, 2016, 20:18 | #2 |
Premier Member
Last Online: Feb 4th, 2023 15:10
Join Date: Apr 2015
Location: uk
|
2 torxt25 screws under pull handle then use plastic bone remove 1/4 panel the door panel lifts up and NOT pulled out as you would normally remove a door panel disconected latch cable then speaker plug and pdm or ddm plug
|
Jan 14th, 2016, 21:57 | #3 |
New Member
Last Online: Nov 19th, 2023 21:08
Join Date: Oct 2015
Location: OXfordshire
|
Cheers!
|
Jan 15th, 2016, 20:01 | #4 |
Premier Member
Last Online: Feb 4th, 2023 15:10
Join Date: Apr 2015
Location: uk
|
your welcome
|
Jan 24th, 2016, 09:24 | #5 |
New Member
Last Online: Nov 19th, 2023 21:08
Join Date: Oct 2015
Location: OXfordshire
|
Thanks for info Volvoforever knowing the door card lifted helped avoid unnecessary pulling
Quite an Easy Job, Took a little over an hour, taking it easy. 2 Torx under handle V40DoorMirror_001.jpg 1.4 Cover slides up and back off three lugs V40DoorMirror_002.jpg Disconnect speaker and mirror connectors and door card will sit on ground without disconnecting door handle cable. V40DoorMirror_003.jpg There's an extra cover over the forward mirror screw V40DoorMirror_004.jpg Which has a annoying little clip that pulls off V40DoorMirror_005.JPG Last edited by PhilSkill; Jan 24th, 2016 at 09:31. |
The Following User Says Thank You to PhilSkill For This Useful Post: |
Jan 24th, 2016, 09:27 | #6 |
New Member
Last Online: Nov 19th, 2023 21:08
Join Date: Oct 2015
Location: OXfordshire
|
New unit from Volvo as supplied
V40DoorMirror_006.jpg V40DoorMirror_007.jpg There's a handy little clip holds the mirror in place while 3 bolts are done up. V40DoorMirror_008.jpg Just clip the cover and mirror back in connecting heated mirror wires. Job Done! |
Jan 24th, 2016, 16:44 | #7 |
Premier Member
Last Online: Feb 4th, 2023 15:10
Join Date: Apr 2015
Location: uk
|
your very welcome
|
Jan 14th, 2019, 09:25 | #8 |
New Member
Last Online: Jan 14th, 2019 09:25
Join Date: Jan 2019
Location: Dublin
|
Thanks a lot for posting, did you have any trouble with the new unit when screwing the bolts back in? Did you use the same bolts? I found it very hard to install using the old bolts. Maybe the new unit is not tapped from the factory? CB
|
Jan 23rd, 2019, 09:15 | #9 | |
New Member
Last Online: Jan 7th, 2023 20:33
Join Date: Jan 2019
Location: Zagreb
|
Quote:
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|