|
200 Series Articles How to's and Guides for the 200 series. |
![]() |
|
Correct fitment of HT leadsViews : 4128 Replies : 1Users Viewing This Thread : |
|
Thread Tools | Display Modes |
![]() |
#1 |
Former contributor
Last Online: Jul 2nd, 2022 07:54
Join Date: Dec 2004
Location: Rhosgoch, Anglesey
|
![]()
For most 240 owners the HT leads have lost their original retaining devices. i always use Volvo leads as they are high quality and have the correct ends as well as being the correct length. The Volvo leads come as a set of 4 - the King (coil) lead comes seperately (always ask for both) as the coil's position changed during the production run resulting in different length leads.
Starting from the distributor cap they go into a circular retainer. This should be positioned close to the manifold - without this there is serious risk of the leads rubbing against the manifold (there is a sharp edge). I have seen a fairly new lead short out because of this. Next there is a clip holding it onto the cam cover with a second one sat on the cover: ![]() There are then two clips bolted on to the cam cover holding the leads for cylinders 1 & 4. This enables all leads to be securely held without risk of touching each other or rubbing against any part of the engine: ![]() This will help ensure that your HT leads stay in optimum condition for as long as possible as well as keeping the engine bay tidy. All these parts are still available from Volvo and are not expensive. The plastic clips are a seperate part from the metal holder. Mike
__________________
A Volvo is for life not just for Christmas! ![]() ![]() |
![]() |
The Following User Says Thank You to Mike_Brace For This Useful Post: |
![]() |
#2 |
Not an expert but ...
Last Online: Yesterday 08:04
Join Date: Dec 2001
Location: Boncath
|
![]()
The unsupported clip (by the final O in VOLVO) can rattle irritatingly on the cam cover, which also over time wears a mark across the lettering. Cut a 3" length of rubber tube, slit it lengthways, and slide on the underside.
I have seen kits that have no.3 lead angled slightly at the plug end. This gives a much better line of clearance between the brake cylinder and the engine lifting eye. Tip for replacing the leads: do them one at a time! |
![]() |
The Following 2 Users Say Thank You to Clifford Pope For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|