|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
Information |
|
Voltage supply issuesViews : 1141 Replies : 17Users Viewing This Thread : |
|
Thread Tools | Display Modes |
|
Dec 10th, 2017, 16:18 | #1 |
Junior Member
Last Online: Jan 11th, 2019 06:37
Join Date: Jul 2017
Location: Tremelo
|
Voltage supply issues
Hi everyone,
It was the first day of snow here in Belgium and apparently my c30 2.0d does not like it one bit. While driving my radio stops working all the time and restarts. Sometimes works for 5 minutes sometimes for 10seconds. About 10 times in a trip of 1,5hours, a couple of lights in the dashboard light up for about half a second. I looks like anti-skid service is required is also on the dashboard then. This message also disappears within half a second. One of those times I felt a big "bump" in the engine (definatly not the road;-)). So I got home, hooked up vida and got following errors (see attached image for extra info) BCM-0058 Bcm-0118 CEM-8F24 ADM-E010 ECM-2135 CEM-DF11 PAM-E010 Battery was replaced very recently. Anyone any ideas? :-) |
Dec 10th, 2017, 16:31 | #2 | |
Experienced Member
Last Online: Today 12:31
Join Date: Jun 2007
Location: L/H side
|
Quote:
__________________
My comments are only based on my opinions and vast experience . |
|
Dec 10th, 2017, 17:37 | #3 |
Junior Member
Last Online: Jan 11th, 2019 06:37
Join Date: Jul 2017
Location: Tremelo
|
Just did, voltage was 14.57V
|
Dec 10th, 2017, 17:44 | #4 |
Experienced Member
Last Online: Today 12:31
Join Date: Jun 2007
Location: L/H side
|
Perhaps it intermittently goes high as several of those codes indicate high voltage
__________________
My comments are only based on my opinions and vast experience . |
Dec 10th, 2017, 18:11 | #5 |
Junior Member
Last Online: Jan 11th, 2019 06:37
Join Date: Jul 2017
Location: Tremelo
|
It does look like that indeed.. I cleared the errors, started the engine and the errors stay out.. Will drive it tommorow and see what it does..
|
Dec 11th, 2017, 18:48 | #6 |
Junior Member
Last Online: Jan 11th, 2019 06:37
Join Date: Jul 2017
Location: Tremelo
|
After 2 short drives of about 40km in total I had no issues with voltage.. I did get into limp mode a lot due too something with the accelerator pedal (ecm 2135) AP position sensor faulty signal. Always gone after restarting the engine.. Any ideas here?
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|