|
Information |
|
ABS sensor resistanceViews : 905 Replies : 2Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jul 15th, 2023, 12:46 | #1 |
New Member
Last Online: Aug 11th, 2023 21:51
Join Date: Jul 2023
Location: Staffordshire
|
ABS sensor resistance
Hi all,
Driving along the other day, braked and I got an ABS warning, DSTC warning, city safety warning, and a couple of others. I read up and found it could be a sensor but without a reader didnt know which so trial and error I also read to test the resistance. Problem is I’ve removed both front sensors and one of the back sensors - all read 1 on my multimeter when it’s set to 20k ohms. Tested the multimeter on a resistor and it’s fine. Why would all three sensors read nothing? Am I doing something wrong? Thanks |
Oct 14th, 2023, 19:20 | #2 |
New Member
Last Online: Feb 5th, 2024 22:38
Join Date: Oct 2023
Location: leeds
|
I had same problem and did a diagnostic and found it was rear left wheel sensor
Replaced and after driving cleared all faults cost me £13 for sensor plus 1 hour to replace On the faulty sensor I did a resistance reading and it was 0.3 ohms must admit did not check new one So checking ohms does not say good or bad You need to run diagnostic to see which sensor is not working replace that sensor and hope this cures problem, did for me |
Oct 20th, 2023, 17:31 | #3 |
Bungling Amateur
Last Online: Today 00:22
Join Date: Aug 2014
Location: Beverley, East Yorks
|
I would just pay to get it plugged in and the codes read... it will save you hours in poke and hope diagnosis, it may not be the sensors at all.
__________________
2011 XC90 D5 Executive 2003 C70 T5 GT 2012 Ford Ranger XL SC 1977 Triumph Spitfire 1500 1976 Massey Ferguson 135 |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|