|
Information |
|
Trouble getting cat-to-downpipe joint to sealViews : 235 Replies : 1Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Sep 13th, 2018, 19:37 | #1 |
Ye olde Volvii galore!
Last Online: Dec 18th, 2023 11:23
Join Date: Oct 2017
Location: Sherborne
|
Trouble getting cat-to-downpipe joint to seal
Hi all,
I fitted a new Lambda sensor today, but the old one was so badly rusted into place I had to remove the cat and use a very lengthy breaker bar to get it to shift. New Lambda is in, car runs fine, except for the fact that the cat>downpipe joint is blowing. It has the two swaged flange sections with the sealing ring between them, all surfaces were slightly pitted and rusty but were sealing just fine before I dismantled it. Does anyone have any tips on how to get it to seal nicely again? Or am i looking at a new cat and downpipe to get a clean seal?
__________________
Barges of Distinction: '96 945 SE LPT M90 '95 945 GLE D24TIC M90 ‘88 745 GL B200E M47 |
Sep 13th, 2018, 21:54 | #2 |
Ye olde Volvii galore!
Last Online: Dec 18th, 2023 11:23
Join Date: Oct 2017
Location: Sherborne
|
Somehow this ended up here! Please delete
__________________
Barges of Distinction: '96 945 SE LPT M90 '95 945 GLE D24TIC M90 ‘88 745 GL B200E M47 |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|