|
LPG, CNG & LNG - General Info and Issues Share experiences and problems |
Information |
|
Volvo V70(P2) 2006 - stepper motor fault (or not?)Views : 1357 Replies : 2Users Viewing This Thread : |
|
Thread Tools | Display Modes |
May 24th, 2019, 15:20 | #1 |
New Member
Last Online: Apr 5th, 2024 08:33
Join Date: Nov 2018
Location: Tallinn
|
Volvo V70(P2) 2006 - stepper motor fault (or not?)
Hello everyone
About 3 months ago my Volvo started to die out while driving on CNG. After that I started to comb through different forums and they all pointed to one component - the stepper motor. Before I start the search for a new one (as I've understood by now they are quite rare and a new one costs around 800€) I decided to ask you guys for some insight whether my fears are true or not, so here goes. Behavior: Car starts up fine and switches to gas normally, then after about 5-7 minutes dies out on gas and doesn't automatically switch to petrol (a real pain and embarrassment when I happen to be at a red light when this happens). After switching to petrol and starting the car (sometimes might take about ~10 seconds of cranking to get it started) if I were to switch it to CNG it would also die, the only way of getting it back on gas is to either let the car sit for an hour or to drive for a bit and try again (classic stepper motor issue as far as I can tell), but... When I drive the car on petrol for about 10-15 minutes until it gets warm and then switch to gas the car would make the switch and drive without any problems until performing a restart. Then almost immediately after turning the car on again with gas mode switched on it would die out. The only remedy to that is to start the car in petrol mode, drive for a minute and then switch to gas, then it would again work without cutting out. Seems strange to me... Also after the cut off has happened, starting in petrol mode and switching to gas there would be a clunk and a hissing noise from near where the regulator lives, until the engine dies out. Any thoughts on this? -Karl |
Jun 18th, 2019, 20:03 | #2 |
Classic P80 1999 BiFuel
Last Online: Mar 6th, 2024 00:34
Join Date: Aug 2012
Location: 48mph Middle Lane M4
|
Sounds like classic symptoms to me.
__________________
Bifuel V70 Classic 1999 [The Old Grumpy in the Corner, "When I was a lad... blah, bl**dy blah."] |
Oct 30th, 2019, 15:19 | #3 |
New Member
Last Online: Apr 5th, 2024 08:33
Join Date: Nov 2018
Location: Tallinn
|
I managed to get the problem fixed. In my case it was failed solder joints on the stepper motor PCB leading to the actual stepper motor itself. I just removed the old solder and soldered it again. To my surprise it seems that someone had already done something to the assembly as it was covered with red silicone which was a b... to remove. Anyway, I put the cover back on with some glue and sealed it with electrical tape just to be sure no water got in. Have been driving for 5000km so far without any problems.
(I didnt take many pictures of this procedure, but I attached one showing the solder points. One set of 4 comes from the connector and the other one leads to the stepper motor itself (my guess atleast)) Hope that someone finds this useful as these stepper motors are becoming harder to get. -Karl Last edited by SquareOne; Oct 30th, 2019 at 15:21. Reason: Forgot to mention the attached image |
The Following User Says Thank You to SquareOne For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|