|
700/900 Series General Forum for the Volvo 740, 760, 780, 940, 960 & S/V90 cars |
Information |
|
7 seat conversionViews : 771 Replies : 1Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Apr 1st, 2005, 20:59 | #1 |
Guest
Location:
|
7 seat conversion
HELP, Trying to fit 7 seat conversion, seat went in alright, but how do the seatbelts fit ? Diagrams would be nice. thanks gorgall
|
Apr 2nd, 2005, 01:27 | #2 |
Aye - him again
Last Online: Today 08:27
Join Date: May 2001
Location: HAWICK
|
RE: 7 seat conversion
Hi Gordon,
I do not have a set of installation instructions but I have attached a photograph of the seat and belts as fitted in my 760. The layout will be the same. The central anchor point is quite obvious as the bolt hole in the middle of the front wall of the spare wheel well. The fixed ends of the belts are at the bottom of the wheel arches. You may have to feel with a bradall or similar for the bolt hole and then cut the carpet around it. (Cut this as a flap that can go back should you take the seat out later.) The middle anchor points are in the side of the roof. There should be plastic covers to remove to get at the bolt holes. Keep the flaps for later use or juat trim them to let the swivel plate work. The inertia reels are on the top of the wheel arches under the square lump of trim. There should be a slot for the belt here. I hope this is of some help. Sorry, photo will not attach here (probably too big for this club facility). Please send your direct email address and I will send it on.
__________________
(Ouch - that's another knuckle ...) VOC 11817 |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|