|
700/900 Series General Forum for the Volvo 740, 760, 780, 940, 960 & S/V90 cars |
Information |
|
ABS controller fuse - where?Views : 2950 Replies : 50Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Mar 4th, 2024, 12:35 | #11 |
Master Member
Last Online: May 8th, 2024 15:43
Join Date: Feb 2006
Location: Amersfoort (NL)
|
Fuse
Fuse 24
|
Mar 4th, 2024, 15:31 | #12 | ||
Member
Last Online: Today 10:01
Join Date: Jul 2018
Location: Huddersfield
|
Quote:
Quote:
Correct, I've checked that one and it's all good. I'd just read about a second fuse elsewhere. |
||
Mar 4th, 2024, 15:41 | #13 | |
Premier Member
Last Online: May 9th, 2024 22:03
Join Date: Jul 2012
Location: Lenzie
|
Quote:
There is a little panel at the bottom of the centre console in the middle. Pop that out and you will see the connector. If the PO didnt know how to find that or have a specific code reader it would be easier to just remove the bulb and hope an MOT tester thought the car was too old to have ABS Changing the wheel sensor can be a bit of a pain as it will be rusted in after the best part of 30 years. The bolts holding it in will be buggered and you will have to chisel the old sensor out of the bottom of the strut
__________________
V70 D5 SE Geartronic 215bhp Saville Grey 2012MY 940 LPT Manual 1996 740 SE 1990 Last edited by griston64; Mar 4th, 2024 at 15:43. |
|
Mar 4th, 2024, 19:30 | #14 |
Senior Member
Last Online: Yesterday 19:20
Join Date: Jul 2019
Location: Stoke on trent
|
Mark its not a bad job .I found it easy to drill out the old sensor .and clean the hub hole up with a rat tail file. My car is 1995 model so has the fault finder set up .probably biggest job is getting the wheel bearing off its a big nut . The sensor fixing bolt after being well oiled with WD40 . It's too risky to hope the MOT inspector miss the ABS bulb being disconnected. Then have to go through the whole process so .Best to do the job right 1st time
|
Mar 4th, 2024, 19:42 | #15 |
Senior Member
Last Online: Yesterday 19:20
Join Date: Jul 2019
Location: Stoke on trent
|
Hi Dean if the D24 is new to you there are a few things unique to this engine . I can do a lot of basic maintenance .but not the cambelt injection pump .waterpump.idler and tensioner job . If you are certain this job has been done within 60000 miles then all OK if not its imperative its done ASAP a broken cambelt destroyed these engines dead!
|
Mar 4th, 2024, 19:46 | #16 | |
Premier Member
Last Online: May 9th, 2024 22:03
Join Date: Jul 2012
Location: Lenzie
|
Quote:
__________________
V70 D5 SE Geartronic 215bhp Saville Grey 2012MY 940 LPT Manual 1996 740 SE 1990 |
|
Mar 4th, 2024, 20:02 | #17 |
Master Member
Last Online: May 8th, 2024 15:43
Join Date: Feb 2006
Location: Amersfoort (NL)
|
LED lights?
No LED brake lights by any chance? No cruise control problems as well?
|
Mar 4th, 2024, 22:11 | #18 | |
Member
Last Online: Today 10:01
Join Date: Jul 2018
Location: Huddersfield
|
Quote:
The car doesn't have cruise as far as I'm aware. Nor LED brake lights. Unless you mean the central brake light which does work. |
|
Mar 5th, 2024, 07:11 | #19 |
Senior Member
Last Online: Yesterday 19:20
Join Date: Jul 2019
Location: Stoke on trent
|
Hi does car start 1st time every time .these engines always do if timing is correct .bit of blue smoke for 30 seconds and then gone. Bad starting is normally .GLOW PLUGS or timing. Oil should be now fully synthetic .5 w 40..have you been on the D24.com American forum its excellent forum too !
|
Mar 5th, 2024, 12:23 | #20 |
Member
Last Online: Today 10:01
Join Date: Jul 2018
Location: Huddersfield
|
I suspect it has a poor battery but generally it starts ok yes. I've had a quick look on d24 and I think I'll be in need of it soon to sort some other issues.
Had a look in the centre console just now, it does have the OBD 1 port so it looks like I need to make a reader. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|