DPF Parameter Vida V50 DPF pressure sensor

[Spikermundo]

Hi all in Vida 2013 does anyone know which tab i need for the DPF parameters, getting signal too high on the pressure sensor and wanted to check the values i have on a garage test report.

[Simmy]

ecm engine control module. there is a you tube vid on forced regen which shows vida screen shot to use

[Spikermundo]

Thanks for the reply got past that part but now stuck on replacement of particulate filter pressure sensor registering a new part seen a screenshot but not sure where it is in Vida

[Simmy]

scroll upto the xc90 section some one has posted this info today with a full descrption of the adaptation its same for v50

[Spikermundo]

Hi yes that was me asking where it was in Vida but I don't seem to have the adaptation part

[Simmy]

make shure to scroll to th bottom of vida screens sometimes info is hidden at the bottom of the page also check for breaks in the pressure sensor wire near the connecting plug

[Spikermundo]

Plugged my wife's V40 2.0 to vida and the adaptation of sensor instruction is there but no instruction for the D4146T just take out and put back in reverse order so assume it does not need it. Checked the wires as the DPF thermostat wire had broken at the connection which i think caused DPF to burn out was advised it will have holes in the honeycomb. Good advice scrolling down as previous searches were down the screen and not obvious, much more information available than i thought.

[Simmy]

dpf sensor may re configure its self but it may take several journeys before this happens delete all prievious codes and work from there.