|
S80 '98-'06 / S60 '00-'09 / V70 & XC70 '00-'07 General Forum for the P2-platform S60 / V70 / XC70 / S80 models |
Information |
|
injector leak...HELPViews : 585 Replies : 12Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Dec 12th, 2018, 12:37 | #1 |
Master Member
Last Online: Sep 25th, 2021 23:16
Join Date: Aug 2017
Location: Sturminster Newton
|
injector leak...HELP
Hello
My number 1 injector leaks from the top,at frist i though it was the leak off tube so i replace it. but as you can see in photo, it leaks from the top i think its the seal i have seal but to small......ANY IDEAS PLEASE as i start the car it leaks like you see in photo.....i have no smoke it just leaks Many thanks |
Dec 12th, 2018, 12:50 | #2 |
Master Member
Last Online: Sep 25th, 2021 23:16
Join Date: Aug 2017
Location: Sturminster Newton
|
update i have changed the seal now it bubbles from where it goes in the engine......
|
Dec 12th, 2018, 14:21 | #3 |
Master Member
Last Online: Sep 25th, 2021 23:16
Join Date: Aug 2017
Location: Sturminster Newton
|
200 XC70 D5 awd
i removed the injector.....2 months ago i have replaced the washers all was clean. The injector is how you guys can see. all the others are ok and clean....is this a goner???? Thank you |
Dec 12th, 2018, 14:58 | #4 |
Experienced Member
Last Online: Today 14:49
Join Date: Jun 2007
Location: L/H side
|
if the injector is not leaking from the top connection or the inlet metal pipe joint it will need a new injector . have a close look at where the metal pipe fits , if it leaks there it could be the pipe joint, you say you have had the injector out , did you replace the pipe and metal clamp? you must do everytime you take an injector out ...
__________________
My comments are only based on my opinions and vast experience . |
The Following User Says Thank You to Clan For This Useful Post: |
Dec 12th, 2018, 15:05 | #5 |
Master Member
Last Online: Sep 25th, 2021 23:16
Join Date: Aug 2017
Location: Sturminster Newton
|
At first it was from the leak of tube...then i have replace the tube and seals. then it started fron where it goes in the engine.....But there was so much carbon build up...
Last edited by Anubisxc70; Dec 12th, 2018 at 15:08. |
Dec 12th, 2018, 15:07 | #6 |
Experienced Member
Last Online: Today 14:49
Join Date: Jun 2007
Location: L/H side
|
yes the clamps bend when you fit them , they will never give the same clamping force a second use , volvo do a fitting kit for each injector , and pipe . the clamp has no effect on the fuel leak or course.
__________________
My comments are only based on my opinions and vast experience . |
Dec 12th, 2018, 15:21 | #7 |
Master Member
Last Online: Sep 25th, 2021 23:16
Join Date: Aug 2017
Location: Sturminster Newton
|
Thank you Clan
Well all cleaned and fit i start the car there were two clanks and its running ..no leaks. not up or down....so far so good....i will try to post a video.... any advise...you thik the injector is ok? |
Dec 12th, 2018, 15:33 | #8 |
Experienced Member
Last Online: Today 14:49
Join Date: Jun 2007
Location: L/H side
|
you better fit the new kit and pipe otherwise the injector could move up and down and damage the seat in the head
__________________
My comments are only based on my opinions and vast experience . |
Dec 12th, 2018, 15:40 | #9 |
Master Member
Last Online: Sep 25th, 2021 23:16
Join Date: Aug 2017
Location: Sturminster Newton
|
I will buy the kit...
Ok it was running until now..no leaks. Now please watch the video. i know my number two might also need cleaning and replacement kit. But ear the sound of my car can you ear the :BASS : like a BOM BOMB BOM sound... can you notice as i move to the right also the tic tic increases....any ideas?? Do you see anything else it might need attention... Many thanks https://www.youtube.com/watch?v=q21L...ature=youtu.be https://www.youtube.com/watch?v=G8QC...ature=youtu.be |
Dec 12th, 2018, 15:46 | #10 |
Experienced Member
Last Online: Today 14:49
Join Date: Jun 2007
Location: L/H side
|
Yes the Bass is the EGR valve open and doing it's job .. hard to tell the other noises over a video ..
__________________
My comments are only based on my opinions and vast experience . |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|