Changed drive shaft now abs fault. HELP!! - Page 2

aland · May 23rd, 2018, 13:12

Quote:

Originally Posted by stevemac1977

Where would I find the Brake fluid sensor so I can check if it's connected?

On the brake master cylinder reservoir

Quote:

Originally Posted by stevemac1977

Weirdly, today I went out and the engine system service warning was there but the Brake Failure Stop Safely message didn't come on for 5 miles?!!

That suggests it probably is a poor connection or fluid level issue.
The engine fault needs the codes reading. Did the turbo pipes get disturbed when you changed the driveshaft?

oragex · May 23rd, 2018, 14:33

Just throwing a wild guess here, 10 minutes after parking the car, open the trunk lid alone with the remote and remove the REM fuse to turn the trunk lights off (any light on will influence the reading). What is the battery voltage?

stevemac1977 · May 23rd, 2018, 15:05

So I've topped up the Brake fluid as it was a touch low and cleaned the contacts on the fluid sensor and reattached. No change.
I'm going to check the battery next.
Starting to agree with some that it's a communications issue.
I assume that having the codes read would confirm this?
Anyone in Leeds with a code reader by any chance? 🤞

May 23rd, 2018, 14:33	#12
oragex Premier Member Last Online: Jul 26th, 2021 21:24 Join Date: Jun 2013 Location: Coldnada	Just throwing a wild guess here, 10 minutes after parking the car, open the trunk lid alone with the remote and remove the REM fuse to turn the trunk lights off (any light on will influence the reading). What is the battery voltage? __________________ Several Volvo Repair Videos https://www.youtube.com/playlist?lis...ECTts0FSVSOT_c

May 23rd, 2018, 15:05	#13
stevemac1977 New Member Last Online: Sep 30th, 2019 17:54 Join Date: Mar 2015 Location: Leeds	So I've topped up the Brake fluid as it was a touch low and cleaned the contacts on the fluid sensor and reattached. No change. I'm going to check the battery next. Starting to agree with some that it's a communications issue. I assume that having the codes read would confirm this? Anyone in Leeds with a code reader by any chance? 🤞

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)