2010 XC 60 Trailer light wiring

[wazrabxc60]

Good evening All

Purchased a 2010 xc 60 and I'm planning to fit a towbar to it as it currently does not have one.

However just like the car in question it seems like its over complicated, I'm not a fan of scotch clips/locks I believe they're called so I'd quite like to fit the wiring the correct way.

Sounds simple but it isn't I need a module and wiring. module ok fine i'll get one of those wiring if i can find out the correct plug I can make that up or buy it . Probably all the same on all models.

However I've now tried to search all over the net to find where it plugs in within the car, back left side by the fuses often is mentioned, Wiring loom to plug into module is taped up I read.

So where on earth is it? do I have to pull all the trim out to locate it only I cannot see any plug in the back that I can plug into a trailer module once I buy one. I've looked behind both of the removable panels left and right and pulled the insulation out but cannot see a spare plug

Could someone please point me in the right direction before I start pulling the trim out

Many thanks in advance

[Whyman]

Go to the Website accessories.volvocars.com and put in your car details and then look in the ack and load section for towbar and wiring installation. If you click on an item a new page will open with a link to the installation instructions which will give full instructions.